manual text

LEGEND

A: YOKE
B: BOX PLEAT
C: LEFT FRONT PANEL
D: RIGHT FRONT PANEL
E: RIGHT SHOULDER
F: LEFT SHOULDER
G: COLLAR
H: RIGHT CUFF
I: LEFT CUFF
J: RIGHT SLEEVE
K: LEFT SLEEVE
L: LEFT FRONT POCKET
M: RIGHT FACET
N: LEFT FACET

--------------

SKEWED LEFT PANEL

PRESS PER STANDARD IRONING INSTRUCTIONS. STOP BEFORE BUTTONING FRONT LAPELS.
WITH SHIRT FACING OUT, FASTEN SECOND BUTTON INTO BUTTONHOLE AT COLLAR. CONTINUE FASTENING BUTTONS IN SEQUENCE, SKIPPING THE FOURTH BUTTONHOLE.
LAY SHIRT WITH THE FRONT FACING DOWN ON THE IRONING BOARD. FOLD THE RIGHT FACET IN TOWARDS CENTER TWO AND A HALF INCHES FROM THE OUTSIDE EDGE (1). CREASE FROM YOKE TO TAIL HEM.
FOLD RIGHT SLEEVE DOWN, ALIGNING IT WITH THE FACET CREASE (2). PRESS FOLD AT SHOULDER. REPEAT FOR LEFT SIDE (3-4).
FOLD TAIL HEM TO YOKE AND TURN SHIRT OVER. EXCESS MATERIAL OF LEFT FRONT PANEL WILL EXTEND BEYOND RIGHT FRONT PANEL (5-6). PRESS LIGHTLY.|

Disclaimer: Religious and political views expressed on this site are those only of the invited author/s, they do not represent or bare claim to views or opinions of e-flux.com. Executing any of the instructions on this website is entirely at your own risk.

Conditions: Should you decide to make this instruction, please send us a picture, your name and the instruction's reference number, and it will probably be added to this page.

Credits: DO IT is a project curated by Hans-Ulrich Obrist. / DO IT at E-flux is produced and presented by electronic flux corp. that holds all the publishing rights, copyrights are held by the respective authors. / Architecture, Design and Development by FDTdesign, NY.