manual text

LEGEND

A: YOKE
B: BOX PLEAT
C: LEFT FRONT PANEL
D: RIGHT FRONT PANEL
E: RIGHT SHOULDER
F: LEFT SHOULDER
G: COLLAR
H: RIGHT CUFF
I: LEFT CUFF
J: RIGHT SLEEVE
K: LEFT SLEEVE
L: LEFT FRONT POCKET
M: RIGHT FACET
N: LEFT FACET

--------------

LAPEL FOLD WITH CRUMPLED PANELS

CENTER REAR YOKE ON IRONING BOARD WITH THE INSIDE FACING OUT. PRESS THE COLLAR. FOLD THE COLLAR OVER AND PRESS A CRISP CREASE (1).
FASTEN BUTTONS ON FRONT PANEL.
PLACE SHIRT ON A TOWEL ON THE FLOOR WITH THE FRONT FACING UP. FOLD THE RIGHT FRONT PANEL UNDER ITSELF. THE FOLD SHOULD FORM A DIAGONAL LINE FROM TWO INCHES INSIDE THE SHOULDER TO THE SIXTH BUTTON (2). PRESS PANEL TO THE INSIDE OF THE FOLD. REPEAT FOR THE LEFT PANEL (3).
CRUMPLE FABRIC OF RIGHT PANEL, SLEEVE, AND SHOULDER. BE CAREFUL TO MAINTAIN FOLD. PRESS CRUMPLED FABRIC.
PLACE LEFT CUFF OVER LEFT PANEL WHILE MAINTAINING CRUMPLED PATTERN. PRESS CUFF. REPEAT FOR RIGHT CUFF.|

Disclaimer: Religious and political views expressed on this site are those only of the invited author/s, they do not represent or bare claim to views or opinions of e-flux.com. Executing any of the instructions on this website is entirely at your own risk.

Conditions: Should you decide to make this instruction, please send us a picture, your name and the instruction's reference number, and it will probably be added to this page.

Credits: DO IT is a project curated by Hans-Ulrich Obrist. / DO IT at E-flux is produced and presented by electronic flux corp. that holds all the publishing rights, copyrights are held by the respective authors. / Architecture, Design and Development by FDTdesign, NY.