manual text

LEGEND

A: YOKE
B: BOX PLEAT
C: LEFT FRONT PANEL
D: RIGHT FRONT PANEL
E: RIGHT SHOULDER
F: LEFT SHOULDER
G: COLLAR
H: RIGHT CUFF
I: LEFT CUFF
J: RIGHT SLEEVE
K: LEFT SLEEVE
L: LEFT FRONT POCKET
M: RIGHT FACET
N: LEFT FACET

--------------

CUFFS THROUGH THE COLLAR

PRESS PER STANDARD IRONING INSTRUCTIONS. STOP BEFORE FOLDING THE FACET.
PLACE SHIRT ON A WIRE HANGER. USING TWINE, SUSPEND SHIRT ABOVE IRONING BOARD IN SUCH A WAY IT MAY BE LOWERED INCREMENTALLY.
PLACE BOTTOM HEM OF SHIRT ON BOARD IN A DIAMOND PATTERN. PRESS A ONE INCH FOLD IN BOTTOM OF SHIRT (1). LOWER SHIRT AND CONTINUE PRESSING ACCORDIAN FOLDS UNTIL ARMPIT OF THE SHIRT REST ON THE BOARD (2-10).
REMOVE TWINE AND WIRE HANGER FROM SHIRT. COLLAPSE COLLAR INTO CENTER OF DIAMOND. EXTEND SLEEVES STRAIGHT OUT. A FOLD WILL FORM ON THE BACK AND FRONT OF THE SLEEVES (11-12). PRESS SLEEVES.

FOLD LEFT SLEEVE UNDER SHIRT (13). PULL CUFF THROUGH COLLAR AND LAY OVER LEFT SHOULDER (14). REPEAT FOR RIGHT SLEEVE (15-16).|

Disclaimer: Religious and political views expressed on this site are those only of the invited author/s, they do not represent or bare claim to views or opinions of e-flux.com. Executing any of the instructions on this website is entirely at your own risk.

Conditions: Should you decide to make this instruction, please send us a picture, your name and the instruction's reference number, and it will probably be added to this page.

Credits: DO IT is a project curated by Hans-Ulrich Obrist. / DO IT at E-flux is produced and presented by electronic flux corp. that holds all the publishing rights, copyrights are held by the respective authors. / Architecture, Design and Development by FDTdesign, NY.